AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Jomic fix color3/19/2023 ![]() Get medical attention if irritation persists. Rinse thoroughly with fresh warm water for at least five minutes or until all residue is removed. Wash affected skin thoroughly with warm water and soap. SKIN CONTACT: Remove contaminated clothing.EYE CONTACT: If you get Porc-A-Fix in your eyes, immediately flush eyes with large amounts of fresh warm water for fifteen minutes.Get medical attention if breathing problems persist. Do not induce vomiting unless directed by a physician. INGESTION: Drink one or two glasses of water to dilute.Paint is an eye irritant and may cause skin irritation or rash with prolonged contact. As with any paint product, wear protective glasses and rubber or neoprene gloves if possible, to reduce chances of eye and skin contact.Until dry, Porc-A-Fix is flammable, so store and use away from heat, sparks and open flames.Keep bottle tightly closed when not in use and out of the reach of children.This will reduce the chance of scratches from surface dirt or abrasion. Do not use harsh chemicals or abrasive cleaners on the repaired area. Post-Operative Careįor routine cleaning of the repaired area, use a mild liquid abrasive or dishwashing liquid we recommend this not only for the repaired area, but for the entire fixture. Then buff the repair and surrounding area with a soft cloth and a bit of automotive polishing compound. Note: for many minor repairs, sanding after the final coat may not be necessary. If you do, sand just until the glaze is smooth with the surrounding porcelain, gently to avoid sanding through the glaze. You may first fine-finish the repaired area with 360-600 grit silicon carbide sandpaper to save buffing time. You may use the enclosed 220-grit finishing paper, or use additional paper of similar or finer grit as you deem fit.įinish. If any brush marks remain, or if any debris has settled into the repair, sand very lightly after drying to remove these imperfections. Use a back and forth fanning motion with the hair dryer - do not hold it stationary over one area.ĭry for 24 hours after the last layer is applied. The drying time can be decreased to several minutes by using a hand held hair dryer on the coolest setting, held at least one foot away from the repair. Open the cap carefully, making sure to wipe off any excess material on the lip of the bottle with a cloth.Īpply in thin layers, allowing at least one hour drying time between coats. This will allow excess material on the cap or brush to roll back into the bottle. Shake the bottle for at least 30 seconds and allow it to sit for at least one minute prior to opening the cap. The small cut of 1" x 3" allows more selective sanding of small repair areas.įor deep chips and gouges, you should first fill them with Fill-A-Fix before using Porc-A-Fix. Though not necessary, for a stronger bond you can carefully rough up the damaged area with the enclosed finishing paper (220 grit aluminum oxide sandpaper). ![]() Ensure that the damaged area and surrounding surface are clean and dry - free of dust, dirt, grease, soap residue, wax and cleaners.
0 Comments
Read More
Leave a Reply. |